Chhattisgarh Police Constable /Quantitative Aptitude

Geometry basics

Speed & Geometry · free study notes

Geometry Basics – Advanced University‑Level Study Notes

(Target audience: students preparing for the “Chhattisgarh Police Constable” Quantitative Aptitude exam but wanting a deep, rigorous understanding. The notes are written from first principles, with proofs, edge‑case discussions, and a challenging problem.)


1. Foundations of Euclidean Geometry

Concept Definition Key Properties Remarks
Point A location in space with no dimension. — Denoted by capital letters (e.g., (P)).
Line A set of points extending infinitely in two directions with no width. Infinite, 1‑dimensional, defined by two distinct points. Represented as (\overline{AB}).
Plane A flat, two‑dimensional surface extending infinitely. Contains infinitely many points and lines. Denoted by a plane symbol (\pi).
Collinearity Three (or more) points lie on the same line. If (A,B,C) collinear, (\overrightarrow{AB} \parallel \overrightarrow{BC}). A degenerate line segment can be viewed as a line.
Coplanarity Four (or more) points lie on the same plane. If (A,B,C,D) coplanar, the four points can be connected by a quadrilateral. A degenerate plane is any set of collinear points.

First Principle: Everything we prove about geometry is ultimately a consequence of the Euclidean axioms (e.g., reflexivity, symmetry, triangle inequality, parallel postulate). The proofs below will use only these axioms implicitly.


2. Angles

2.1 Definitions

  • Angle (\angle XYZ) is formed by two rays ( \overrightarrow{YX} ) and ( \overrightarrow{YZ} ) sharing vertex (Y).
  • Vertex = common point.
  • Sides = the rays.

2.2 Types of Angles

Type Condition Measure (in degrees) Notes
Acute (0^\circ < \angle < 90^\circ) – Smallest angles.
Right (\angle = 90^\circ) 90 Perpendicular lines.
Obtuse (90^\circ < \angle < 180^\circ) – Larger than right.
Straight (\angle = 180^\circ) 180 Collinear rays.
Reflex (180^\circ < \angle < 360^\circ) – Larger than straight.

2.3 Angle Addition & Subtraction

  • Angle Addition: If (B) lies on the interior of (\angle ABC), then
    [ \angle ABC = \angle ABP + \angle PBC. ]
  • Angle Subtraction: If (D) is between (B) and (C) on the same ray,
    [ \angle ABD = \angle ABC - \angle DBC. ]

2.4 Angle Sum Theorem

For any triangle (\triangle ABC): [ \angle A + \angle B + \angle C = 180^\circ. ] Proof: Extend side (BC) to point (D). By the linear pair property, (\angle BCD = 180^\circ). Then (\angle BCD = \angle BCA + \angle ACB). Since (\angle B + \angle C = \angle BCA + \angle ACB), we have the desired result.


3. Triangles

3.1 Types (by sides)

  • Equilateral: All sides equal.
  • Isosceles: Two sides equal.
  • Scalene: All sides distinct.

3.2 Types (by angles)

  • Acute: All angles < 90°.
  • Right: One angle = 90°.
  • Obtuse: One angle > 90°.

3.3 Triangle Inequality

For any triangle (\triangle ABC): [ AB + BC > AC,\quad BC + AC > AB,\quad AC + AB > BC. ] Proof: Consider triangle (\triangle ABC). Draw altitude from (A) onto (BC), then the sum of two legs of the right triangles formed will always exceed the base (BC).

3.4 Congruence Criteria

Criterion Conditions Proof Sketch
SSS (Side–Side–Side) (AB = DE,\ BC = EF,\ AC = DF) Translate ( \triangle ABC) onto ( \triangle DEF); if all sides match, the triangles overlap exactly.
SAS (Side–Angle–Side) (AB = DE,\ \angle ABC = \angle DEF,\ BC = EF) Construct the triangle with the given sides and angle; uniqueness follows from the law of cosines.
ASA (Angle–Side–Angle) (\angle A = \angle D,\ AB = DE,\ \angle B = \angle E) Similar to SAS by swapping the side to the middle.
AAS (Angle–Angle–Side) (\angle A = \angle D,\ \angle B = \angle E,\ AC = DF) The third angle is determined by the sum‑to‑180° rule; then SAS applies.

3.5 Similarity Criteria

Same as congruence except the side lengths are proportional rather than equal.


4. Pyth

Your note

Page 1

Doubt hai is topic me?

Free AI teacher se poocho — 24/7, step by step.